Answers to common questions about choosing and using reciprocating saw blades for metal and wood.
How do I choose the right number of teeth per inch (TPI) for metal?

The general rule of thumb from blade makers is that the thicker the material, the lower the TPI. Thin sheet, tube and conduit need a higher TPI, while thicker sections need a lower TPI, which clears swarf better and cuts faster but leaves a rougher edge.
Power tool industry safety guidance adds that when cutting metal you should choose a blade that keeps at least three teeth in the material at all times. Fewer than three teeth can snag and break, although a tooth that is too fine will slow the cut. Blades often carry a tooth range as two numbers, and the pack or blade marking shows what it is meant for.
What blade length do I need?

Choose the shortest blade that will do the job but still extends beyond the workpiece throughout the stroke. Power tool industry guidance says this minimises blade flexing and gives a smoother cut, and that blades may shatter if they strike the work or the shoe.
A blade maker's guide suggests working out the length from the depth of cut plus clearance at the tip and the machine's stroke length, then rounding up to the next standard size. Check your saw manual for the stroke length and for any limit on blade length or cutting capacity, and never cut material larger than the rated capacity.
Why do my blades keep bending, snapping or overheating?

Industry safety guidance says a dull blade produces excessive heat and makes cutting difficult, which leads to forcing the saw. A build-up of sap or pitch on the blade, a blade without enough set or clearance, and unguided cuts can all overheat it, and overheating can warp a blade.
Blades can also break if the shoe is not held firmly against the work, if the workpiece moves, or if the wrong blade is used for the job, so clamp the work and use the blade the saw maker recommends. Make sure the blade clamp is tight and the clamping area is clean, as swarf and dust can stop the blade being held securely.
Is vibration from a reciprocating saw a health risk?

Yes, regular use of vibrating hand-held tools can contribute to hand-arm vibration syndrome. The HSE lists early symptoms as tingling and numbness in the fingers, loss of feeling, weaker grip, and fingers that turn white then red and painful in the cold.
The HSE advises choosing the lowest-vibration tool that suits the job, keeping tools maintained with cutting edges sharp, planning work to avoid long continuous exposure, avoiding gripping or forcing the tool harder than necessary, and reporting early symptoms promptly. Your employer's risk assessment should set safe exposure times, so follow it and the saw maker's vibration information.
What safety precautions should I take when using a reciprocating saw?

Power tool industry guidance says to clamp the workpiece securely and never hold it by hand or across your leg, hold the saw firmly with both hands, and firmly position the shoe on the work before starting, keeping it in contact throughout the cut. Check what is behind the workpiece for hidden pipes or wiring before you cut.
Check the blade before each use and never use a bent, broken or warped blade. The blade and clamp can be hot straight after cutting, so avoid contact until they cool, and unplug the saw or remove the battery before changing blades or moving to another workstation. Follow the saw maker's instructions and wear eye protection as your risk assessment requires.
How do I cut thin sheet or tube without the blade grabbing?

Use a finer-pitch blade so that at least three teeth are in the material at all times. Industry guidance warns that fewer than three teeth in the cut cause snagging and breakage.
Small or thin material can flex or vibrate with the blade and cause loss of control, so clamp it securely, support it close to the cut, and keep the shoe firmly in contact with the work. Let the blade reach full speed before it touches the workpiece, because the saw can chatter if the blade is slow at the start of the cut. A coarse blade tends to snatch at thin metal.