FEIN Premium Angle Grinders FAQs
Answers to common questions about choosing, using and looking after a premium brushless angle grinder.
Does the disc have to be rated for the grinder's speed?

Yes. The rated speed of any disc or accessory must be at least equal to the maximum speed marked on the grinder. A disc that is rated lower than the grinder can run at can break up in use, and that is a serious injury risk.
With a variable-speed grinder, check the highest no-load speed on the data plate, not the speed you plan to use, and compare it with the maximum operating speed printed on every disc. Never fit a disc whose rating is lower, and do not guess if the marking has worn off.
If you are unsure, check the grinder manual and the disc maker's instructions, or ask our team.
What is kickback and how do I reduce the risk?

Kickback is a sudden reaction when a spinning disc is pinched or snagged. It throws the grinder in the direction opposite to the disc's rotation at the point where it caught, and it can happen very quickly.
To reduce the risk, keep a firm two-handed grip with the side handle fitted, and stand so your body is out of the line the grinder would travel. Keep your hand away from the spinning disc, and take care at corners and sharp edges where the disc can bounce or snag.
Some grinders also have electronic monitoring that reacts to a sudden snag, but treat that as a back-up and never as a substitute for good technique. Check the manual for how your model behaves.
How should I fit and test a new disc?

Unplug the grinder first, then check that the disc is the right type and size, and that it is not chipped, cracked or worn out. Do not use a damaged disc. Fit it with the flanges and nut the maker specifies, the right way round and without improvised washers, and tighten it with the key supplied. Follow both the grinder manual and the disc instructions.
Once fitted, with the guard in place, run the grinder at full no-load speed for about a minute with yourself and anyone nearby standing out of line with the disc. If there is any wobble, vibration or noise, stop and fix the cause before starting work.
Do not lay the grinder down until the disc has come to a complete stop.
How can I reduce hand-arm vibration when I grind a lot?

Regular grinding can expose your hands and arms to vibration, which over time may cause lasting nerve and circulation problems. The HSE advises choosing the lowest-vibration tool that does the job properly, comparing the vibration figures that makers publish, and keeping equipment well maintained.
Worn or damaged discs make the grinder work harder, so replace consumables such as grinding wheels when they are worn. Limit continuous time on the tool and take breaks where you can, rather than doing one long spell.
Avoid gripping the grinder harder than you need to. Your employer's risk assessment should set sensible limits for your work.