Straight answers to the questions people ask most when choosing and using TIG welding equipment.
What is TIG welding best for?

TIG gives the most control of any common arc process, so it is chosen when appearance and weld quality matter more than speed. It is widely used on thin material, stainless steel, aluminium, copper alloys, titanium and for root runs on pipe, where a clean, precise weld with no spatter is needed.
The weld pool and the filler rod are controlled separately, which allows very fine adjustment but also makes TIG slower and more demanding than MIG or stick. For fast work on thick, plain steel, other processes are usually a better fit.
Do I need an AC/DC TIG machine or will DC do?

It depends on the metals you weld. A DC-only machine is fine for steel, stainless steel and copper alloys. Aluminium and magnesium need AC, because the alternating current breaks up the tough oxide skin on the surface so the weld pool can form properly.
If you are certain you will never weld aluminium, DC is enough. If there is any chance you will, an AC/DC machine saves you from buying again later. AC machines usually also let you adjust the balance and frequency of the AC to suit the job.
How do I choose the right size of TIG machine?

Start with the thickest material you will weld regularly and look at the maker's guidance on the current needed for it. Higher current is needed for thicker material and for metals that carry heat away quickly, such as aluminium and copper. Then check the duty cycle, which tells you how long the machine can run at a given current before it needs to cool.
Also think about the power supply you have (single-phase or three-phase), whether you need to carry the machine around, and whether you need water cooling for long, high-current welds. Our team can help you match a machine to your work.
How do I choose TIG filler rod?

Match the rod to the metal you are welding, and to the properties you need from the joint. For steel, rods contain deoxidisers that help produce a sound weld. For stainless steel, choose a rod suited to the grade of the parent metal. For aluminium, there are several filler alloys and the best one depends on the alloy being welded and what the part will be used for.
The rod diameter should suit the thickness of the joint and the current. Keep rods clean, dry and identifiable, because a mix-up between types is easy to make and hard to spot later.
How do I get good gas coverage, and what is back purging?

Pure argon is the usual shielding gas for most TIG work. Set the flow so the weld area is covered without turbulence, because too much gas can pull air into the stream. Use the pre-flow and post-flow settings so the gas protects the start of the weld and the tungsten as it cools, check hoses and joints for leaks, and avoid draughts and fans near the weld.
Back purging means filling the inside of a pipe or the back of a joint with inert gas so the underside of the weld is protected. It is commonly used on stainless steel, where unprotected root runs oxidise and look grey and crusty, often called sugaring. Always let the gas escape through a vent and never seal pressure into a closed vessel.
What is the difference between TIG, MIG and stick welding?

MIG feeds a wire continuously and is fast and easy to learn, which makes it a good all-rounder for production and general fabrication. Stick uses a coated electrode, copes well with wind, rust and rough conditions, and suits outdoor and site repair work. TIG uses a non-consumable tungsten electrode with a separate filler rod, giving the neatest and most controlled welds, especially on thin or non-ferrous metals.
TIG is the slowest to do and the hardest to learn, but it produces little spatter and little cleaning work afterwards. The best process depends on the metal, the thickness, where you are working and the finish you need.