WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 64203007010  

    FEIN QuickIn Holesaw Adaptor
    64203007010

    £87.91  EX VAT
    SSP Suggested Selling Price = £111.99  YOU SAVE £24.08
     Buy in 3 easy interest free payments of £29.30† with

    Related Items

    FEIN Drill/Drivers FAQs

    Practical answers on choosing and using 18 V cordless drill/drivers for metalwork, tapping and screwdriving.

    What does the clutch do, and how do I set it?icon-minus-redicon-plus-red

    The clutch is the numbered collar behind the chuck. In screwdriving mode it limits the torque applied, and the drive disengages with a clicking sound once the set torque is reached, which helps prevent overdriving screws or snapping small fasteners. Lower numbers give less torque and higher numbers give more.

    A sensible method is to start low and work upwards on a scrap piece until the fastener seats properly. The drill symbol on the collar bypasses the clutch so the tool gives its full torque, which is the setting for drilling holes. Remember the clutch is a guide rather than a precision torque tool, so use a proper torque wrench where a specified tightening torque matters.

    What do the different gears or speed ranges mean?icon-minus-redicon-plus-red

    Multi-speed drill/drivers have a gearbox that trades speed for torque. The lowest gear gives high torque at low speed and suits heavy-duty work such as large drill bits, hole saws, tapping and driving big fasteners. Higher gears give faster rotation and lower torque for smaller drill bits and light work.

    As a rule, bigger diameters need slower speeds, and tough materials such as stainless steel need slower speeds than mild steel. Only operate the gear selector when the tool is not running, because shifting while it turns can damage the gearbox, and push the selector fully home. The manual and data plate give the speed ranges for your tool.

    How should I charge and look after the battery?icon-minus-redicon-plus-red

    Use the charger supplied with the battery or one the manufacturer recommends. The wrong charger can overload a battery and raise the risk of overheating and fire. Unplug the charger once the battery is full rather than leaving it on continuous charge, and do not leave batteries charging unattended or overnight.

    If a battery has been dropped, or shows overheating, swelling or other damage, stop using it, do not charge it, and dispose of it safely. Keep charging areas clear of escape routes and flammable materials. Your risk assessment and the manufacturer's instructions cover storage and transport rules for your workplace.

    How do I drill stainless steel without ruining the bits?icon-minus-redicon-plus-red

    Stainless steel work hardens when heat builds up from the wrong speed or from rubbing, so the aim is to keep the bit cutting. Use a sharp bit made for tough metals (cobalt bits are commonly used because the cobalt runs right through the bit), a low speed, steady feed so you see continuous chips, and plenty of cutting oil or coolant. Do not let the bit dwell or rub in the hole, and stop regularly to re-apply oil if you cannot keep it flooded.

    For larger holes it often helps to start with a smaller hole and step up. A blunt bit pushes you to press harder and generate more heat, so replace or resharpen bits as soon as they stop cutting freely. Exact speeds depend on the grade and bit size, so check the bit maker's guidance.

    Shop Similar Categories