WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 63131020010  

    FEIN KBH25 Carbide Holesaw 20mm
    63131020010

    £42.71  EX VAT
    SSP Suggested Selling Price = £54.41  YOU SAVE £11.70
     Buy in 3 easy interest free payments of £14.24† with

    FEIN Products FAQs

    Plain answers on choosing and looking after core drilling cutters, motor spares, attachments and carry accessories for industrial drilling tools.

    How do I get the most life out of a core drilling cutter?icon-minus-redicon-plus-red

    Use cutting fluid or paste made for metal cutting every time. Lubricant greatly extends cutter life, and some manuals say the cutter must never run dry. Feed with steady, even pressure, easing off at the start and end of the cut. Leaning hard on the machine because the feed is slow is a common cause of dulling.

    If the cutter jams, stop feeding, disconnect from the supply and free it by turning the arbor by hand rather than switching the motor on and off. Check the cutter before every use and do not use one that is damaged or blunt. Clear chips after use, store cutters so the teeth are not knocked, and check any pilot pin is straight and moves freely. Follow the maker's speed and feed advice for the material.

    What does the workpiece need to be like for the magnet to hold?icon-minus-redicon-plus-red

    Holding force depends on the thickness and condition of the steel. The best hold is on soft steel of enough thickness, and the holding force falls progressively as the steel gets thinner. A steel packing plate under the magnet or the work makes up the thickness. The minimum thickness differs widely between machines, so check your manual.

    Clean the surface first, removing spatter, rust, dirt, grease and metal chips from the base. The magnet only holds while the power is on, and a power loss or overload removes the holding force, so always use the safety strap and check any magnet indicator before you start drilling.

    What should I wear and watch out for when drilling with a cutter?icon-minus-redicon-plus-red

    Wear eye protection and hearing protection, tie long hair back, and keep ties, loose clothing and jewellery away from the rotating parts. Makers differ on gloves: some say to wear gloves against sharp swarf and when handling cutters. Never wear loose gloves near a running cutter, because swarf and rotating parts can catch them, and keep your hands out of the cutting area while the machine runs.

    The slug that drops out can be very hot, and chips are sharp and hot. Do not touch them. Clear them with a brush, hook or magnetic chip collector only after the machine has fully stopped. Follow your risk assessment and the manual for any further protection needed.

    What electrical checks should I make before using the drill?icon-minus-redicon-plus-red

    Before each use, switch off and unplug, then look over the supply cable, plug and casing. Check the cable and equipment before use, and remove damaged or faulty equipment from use without delay. It should be repaired by a competent person or disposed of.

    How often equipment needs a formal inspection or test depends on the risk, including whether it is used in a harsh environment. Drilling tools in workshops or on site are likely to need more than the minimum, so base your checks on your risk assessment and the maker's manual.

    Shop Similar Categories