WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : FEIN-TCT50  

    FEIN TCT Slugger Cutter, 50mm Depth
    FEIN-TCT50

    Select Option 
    Prices From £28.88 ex VAT

    FEIN Slugger Cutters FAQs

    Straight answers to the questions people ask most when choosing and using annular cutters with a quick-change shank.

    What is an annular cutter and why use one instead of a twist drill?icon-minus-redicon-plus-red

    An annular cutter is a hollow cutter that cuts only a ring around the edge of the hole and leaves a solid slug in the middle. Because it removes far less metal than a twist drill, it needs less power, cuts faster and produces a clean, accurate hole in steel.

    They are designed for use in magnetic drills and suit structural steel, plate and sections. For small holes, a twist drill is often simpler, but from moderate sizes upwards an annular cutter is usually the quicker and more efficient choice.

    Should I choose an HSS or a carbide-tipped cutter?icon-minus-redicon-plus-red

    High speed steel cutters are tough, forgiving and well suited to general work in mild steel, including jobs where the drill is hand-fed or the setup is not perfectly rigid. Carbide-tipped cutters last longer and cut faster, and cope better with hard or abrasive materials, but they are more brittle and need a rigid setup and steady feed.

    If you cut a lot of holes in tougher steel, carbide-tipped usually pays off through longer life. For occasional jobs in mild steel, high speed steel is often enough.

    How do I choose the cutting depth of a cutter?icon-minus-redicon-plus-red

    The depth is the thickness the cutter can cut through in one go. Pick a depth at least equal to the thickness of the material you are drilling, and remember to allow for any packing, gap or second layer you are cutting through.

    Most people keep a short cutter for plate and sheet and a deeper one for thick or stacked material. Longer cutters are less rigid, so use the shortest one that does the job.

    What does the centring pin do, and how do I choose one?icon-minus-redicon-plus-red

    The centring pin, or pilot pin, passes through the middle of the cutter. It locates the cutter over the mark, lets coolant flow to the cut, and when the slug is formed, the spring pushes it out.

    The pin has to suit the diameter and depth of the cutter, so match it to the series printed on the cutter or in its documentation. A worn, bent or wrong-length pin causes poor starts, loss of coolant and broken cutters, so replace it when it shows wear.

    Shop Similar Categories