WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 63730022010  

    Fein 125mm Zirconium Flap Disc 40 Grit (Box of 10)
    63730022010

    £32.75  EX VAT
    SSP Suggested Selling Price = £41.72  YOU SAVE £8.97
     Buy in 3 easy interest free payments of £10.92† with

    Abrasive material made from zirconium corundum for excellent surface results with good sanding capacity, offering simple handling and few vibrations. Ideal for machining edges. Long service life with consistent quality of work. Can be used universally in steel and stainless steel. Conical shape, inner diameter of 22.23 mm, maximum speed of 12 250 rpm, maximum working speed of 80 m/s.

    Related Items

    FEIN Products FAQs

    Plain answers on choosing and looking after core drilling cutters, motor spares, attachments and carry accessories for industrial drilling tools.

    What does the workpiece need to be like for the magnet to hold?icon-minus-redicon-plus-red

    Holding force depends on the thickness and condition of the steel. The best hold is on soft steel of enough thickness, and the holding force falls progressively as the steel gets thinner. A steel packing plate under the magnet or the work makes up the thickness. The minimum thickness differs widely between machines, so check your manual.

    Clean the surface first, removing spatter, rust, dirt, grease and metal chips from the base. The magnet only holds while the power is on, and a power loss or overload removes the holding force, so always use the safety strap and check any magnet indicator before you start drilling.

    Is the safety strap really needed, and what about medical implants?icon-minus-redicon-plus-red

    Yes. Use the strap supplied to secure the machine to the work. It matters most on vertical, sloping and overhead work, and on scaffolds, because a power failure can make the machine fall or swing. Check the strap for wear or damage before each use and do not use a damaged one.

    The base magnet is strong and its field can interfere with some implanted medical devices, such as pacemakers. Anyone with an implant should get advice from their doctor or the device maker before using the machine or working close to it, and should read the manual. Keep bystanders in mind and follow your risk assessment.

    What electrical checks should I make before using the drill?icon-minus-redicon-plus-red

    Before each use, switch off and unplug, then look over the supply cable, plug and casing. Check the cable and equipment before use, and remove damaged or faulty equipment from use without delay. It should be repaired by a competent person or disposed of.

    How often equipment needs a formal inspection or test depends on the risk, including whether it is used in a harsh environment. Drilling tools in workshops or on site are likely to need more than the minimum, so base your checks on your risk assessment and the maker's manual.

    How can I reduce vibration when using a hand-held drilling tool?icon-minus-redicon-plus-red

    Use the right tool for each job, which lets you finish sooner with less hand-arm vibration exposure. Check tools before use to make sure they are properly maintained and repaired, because faults and general wear can increase vibration, and keep cutting tools sharp so they stay efficient.

    That applies to cutters as well: a blunt cutter takes longer and pushes you to lean on the tool. If you hold the machine while it cuts, choose suitable low-vibration tools where you can, and follow the vibration information in the manual and your risk assessment.

    Shop Similar Categories