Rapid Ref : W03X0893-76A Mfr Ref : KP2842-2

Lincoln Electric PC208 / PC210 Contact Nozzle 25A (Pack of 5)
KP2842-2 W03X0893-76A

Name: Lincoln Electric PC208 / PC210 Contact Nozzle 25A (Pack of 5)
SKU: W03X0893-76A
Price: 16.67 GBP

£16.67 EX VAT

SSP Suggested Selling Price = £18.51 YOU SAVE £1.84

PC208 / 210 Consumables FAQs

Practical answers on the wearing parts of a light-duty hand plasma torch: what each one does, how to spot wear and how to choose the right replacement.

What parts make up the consumable set on a hand plasma torch like this?

A typical light-duty air plasma torch uses a small stack of wearing parts: an electrode, a nozzle (sometimes called a tip), a gas distributor (also called a swirl ring), a retaining cap that holds the stack together and, on many hand torches, a shield cap or cutting spacer at the front.

The electrode carries the current, the nozzle shapes the arc, and the distributor swirls the gas around them. The front cap or spacer protects the parts from spatter and helps set the working gap. The exact parts and how they fit differ between torches, so check your manual's parts diagram rather than assuming.

How do I work out which consumables fit my torch?

Start with the data plate on the cutter and the torch, then the manual's parts list. Consumables are specific to the torch design and are usually matched to a current rating, so a part that looks similar may not suit your torch.

If you have lost the manual, read any markings or part numbers on the old electrode, nozzle or cap, and compare them with the manufacturer's parts chart. This matters most on used or refurbished machines, where the torch may not be the original one. Our team can help you match parts if you are unsure.

Why should I change the electrode and nozzle together?

They are normally replaced as a pair. A worn electrode can damage the nozzle, and a worn nozzle opening spoils the cut, so a new electrode in a worn nozzle (or the reverse) is unlikely to cut well and the new part may wear quickly.

Maker manuals say to replace the nozzle whenever the electrode is replaced. If one wears out noticeably sooner than the other, changing both at that point is the safest habit. Pre-packed sets of matched parts make this easier.

What are the signs that the nozzle is worn?

The nozzle's centre hole focuses the arc. Look for erosion, a hole that is no longer round, blocked gas holes or damaged O-rings, and replace it if you see any of these. A magnifying glass or loupe helps, and comparing it with a new nozzle shows small changes.

In use, a worn nozzle often gives a wider cut, more dross on the underside and an angled (bevelled) edge. Poor height, speed or settings can cause similar faults, so check those too before blaming the nozzle.

See all 6 questions for this category