Rapid Ref : 228302

Kit: Pmx45 Air Filter Element
228302

Name: Kit: Pmx45 Air Filter Element
SKU: 228302
Price: 28.00 GBP

£28.00 EX VAT

SSP Suggested Selling Price = £32.00 YOU SAVE £4.00

Powermax 125 Machine Systems FAQs

Straight answers to the questions people ask most when choosing a top-end plasma system for mechanised cutting.

What is a high-power machine plasma system used for?

It is used on cutting tables, gantries, bevel heads, pipe cutters and robotic cells that need to cut thick plate quickly and repeatably. The mechanised torch holds a steady height and speed, giving more consistent edges than hand cutting.

It suits steel fabricators, heavy engineering and contract cutters. If you only cut a few parts by eye, a hand system may be simpler.

What do the connections on a machine plasma system do?

A machine plasma system usually has a control connection for the table or robot controller. It lets the controller start and stop the arc and receive signals such as arc transfer. Many systems can also supply a reduced arc voltage signal for a height controller, and some have a serial or network connection for digital control and status information. Some provide remote on/off.

The connections and signals provided differ between makers and models, so check the manual for your machine and confirm that your controller expects the same signals and cables before you buy.

How long should the torch lead be?

It should reach the whole travel of the gantry or carriage without being stretched or snagged. A lead that is too short limits movement and wears quickly; a lead that is too long adds clutter.

Use a drag chain or support on larger tables, and avoid coils, tight bends and pinch points.

How do I get a clean, square edge?

Edge quality depends on current, travel speed, stand-off height, consumable condition and air quality. Use the maker's cut chart as a starting point, then adjust on scrap plate. Slow speeds leave dross and fast speeds leave it trailing behind.

Remember that plasma edges have a natural slight angle, and worn consumables make it worse. Replace them early.

See all 6 questions for this category