SHOW PRICES INCLUDING VAT
Trustpilot
Click to visit the Rapid Blog - Supporting welders every step of the way
WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
127410 Hypertherm System Carry Case for Powermax 30/30XP
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 127410  

    Hypertherm System Carry Case for Powermax 30/30XP
    127410

    £89.25  EX VAT
    SSP Suggested Selling Price = £102.00  YOU SAVE £12.75
     Buy in 3 easy interest free payments of £29.75† with

    Rugged case for protecting and storing the Powermax 30 or 30 XP and accessories.

    Related Items

    Powermax 125 Machine Systems FAQs

    Straight answers to the questions people ask most when choosing a top-end plasma system for mechanised cutting.

    What is a high-power machine plasma system used for?icon-minus-redicon-plus-red

    It is used on cutting tables, gantries, bevel heads, pipe cutters and robotic cells that need to cut thick plate quickly and repeatably. The mechanised torch holds a steady height and speed, giving more consistent edges than hand cutting.

    It suits steel fabricators, heavy engineering and contract cutters. If you only cut a few parts by eye, a hand system may be simpler.

    How long should the torch lead be?icon-minus-redicon-plus-red

    It should reach the whole travel of the gantry or carriage without being stretched or snagged. A lead that is too short limits movement and wears quickly; a lead that is too long adds clutter.

    Use a drag chain or support on larger tables, and avoid coils, tight bends and pinch points.

    What supply and air do I need?icon-minus-redicon-plus-red

    The data plate and manual give the input voltage, number of phases and current drawn. Higher-power machine systems commonly need a three-phase supply, but this varies, so do not assume. The supply, protective device and cabling must suit the figures on the plate and should be installed or checked by a qualified electrician.

    The system also needs a good flow of clean, dry compressed air at the pressure and flow rate stated in the manual. Use a properly sized compressor, filter and moisture separator, with a dryer for heavy use, and check pressure with air flowing.

    How do I get a clean, square edge?icon-minus-redicon-plus-red

    Edge quality depends on current, travel speed, stand-off height, consumable condition and air quality. Use the maker's cut chart as a starting point, then adjust on scrap plate. Slow speeds leave dross and fast speeds leave it trailing behind.

    Remember that plasma edges have a natural slight angle, and worn consumables make it worse. Replace them early.

    See all 6 questions for this category

    Shop Similar Categories