Rapid Ref : 127217

Hypertherm shoulder strap 1.5" width X 50" length, hook w/ latch
127217

Name: Hypertherm shoulder strap 1.5" width X 50" length, hook w/ latch
SKU: 127217
Price: 29.09 GBP

£29.09 EX VAT

SSP Suggested Selling Price = £33.25 YOU SAVE £4.16

The Hypertherm shoulder strap is 1.5"W X 50"L with a hook with latch for Powermax30® XP, Powermax30® AIR, Powermax45®, and Powermax45® XP plasma cutting systems.

Powermax 125 Machine Systems FAQs

Straight answers to the questions people ask most when choosing a top-end plasma system for mechanised cutting.

What do the connections on a machine plasma system do?

A machine plasma system usually has a control connection for the table or robot controller. It lets the controller start and stop the arc and receive signals such as arc transfer. Many systems can also supply a reduced arc voltage signal for a height controller, and some have a serial or network connection for digital control and status information. Some provide remote on/off.

The connections and signals provided differ between makers and models, so check the manual for your machine and confirm that your controller expects the same signals and cables before you buy.

How long should the torch lead be?

It should reach the whole travel of the gantry or carriage without being stretched or snagged. A lead that is too short limits movement and wears quickly; a lead that is too long adds clutter.

Use a drag chain or support on larger tables, and avoid coils, tight bends and pinch points.

What supply and air do I need?

The data plate and manual give the input voltage, number of phases and current drawn. Higher-power machine systems commonly need a three-phase supply, but this varies, so do not assume. The supply, protective device and cabling must suit the figures on the plate and should be installed or checked by a qualified electrician.

The system also needs a good flow of clean, dry compressed air at the pressure and flow rate stated in the manual. Use a properly sized compressor, filter and moisture separator, with a dryer for heavy use, and check pressure with air flowing.

How do I get a clean, square edge?

Edge quality depends on current, travel speed, stand-off height, consumable condition and air quality. Use the maker's cut chart as a starting point, then adjust on scrap plate. Slow speeds leave dross and fast speeds leave it trailing behind.

Remember that plasma edges have a natural slight angle, and worn consumables make it worse. Replace them early.

See all 6 questions for this category